Electrolux Washer - 07E Error Code

The washer detected a temperature sensor (NTC) fault.

Meaning

The washer detected a temperature sensor (NTC) fault.

The Electrolux 07E error code indicates that the washer’s NTC temperature sensor is reporting invalid, out‑of‑range, or unstable readings. The NTC sensor monitors water temperature for heating, chemical activation, and sanitization cycles. If the sensor fails, the washer cannot safely continue operation.

Symptoms

  • Washer stops during heating
  • Water temperature fluctuates
  • 07E appears early in the cycle

Causes

  • Faulty NTC sensor
  • Loose or corroded wiring
  • Short or open circuit in the sensor harness
🔧

Step-by-Step Fixes

  • Test the NTC sensor for correct resistance.
  • Inspect wiring for corrosion or loose connectors.
  • Replace the NTC sensor if defective.
⚠️

Safety Notes

  • Disconnect power before testing electrical components.
📋

Applicable Models

Show Models
  • PW9C
  • PW9C10
  • PW9C12
📁

Related Pages

📁

Other Electrolux Washer Error Codes

Show All Error Codes

Model-Specific Notes

On PW9C models, 07E may appear after thermal shock events caused by rapid hot‑to‑cold water transitions.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.