Whirlpool Washer - F2 Error Code

Stuck key or user interface failure.

Meaning

Stuck key or user interface failure.

The F2 error indicates that the washer’s user interface (UI) has detected a stuck key or unresponsive button. On Whirlpool Cabrio and HE top‑load washers, the UI panel communicates with the main control board through a digital ribbon cable. If a button remains pressed for too long, becomes contaminated with moisture, or if the UI board fails, the washer displays F2 and prevents cycle operation.

Symptoms

  • Buttons do not respond
  • Washer beeps repeatedly
  • Cycle will not start
  • F2 appears immediately after pressing a button

Causes

  • Stuck or damaged button
  • Moisture inside the UI panel
  • Loose or corroded ribbon cable
  • Failed user interface board
🔧

Step-by-Step Fixes

  • Unplug the washer for 5 minutes.
  • Clean the UI panel and ensure no buttons are stuck.
  • Remove the console and reseat the ribbon cable.
  • Replace the UI panel if the error persists.
⚠️

Safety Notes

  • Disconnect power before removing the console.
📋

Applicable Models

Show Models
  • WTW6200VW
  • WTW6300WW
  • WTW6600VW
📁

Related Pages

📁

Other Whirlpool Washer Error Codes

Show All Error Codes

Model-Specific Notes

On early Cabrio models, humidity inside the console frequently causes F2 due to membrane keypad contamination.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.