Whirlpool Washer - F31 Error Code

Pressure switch failure detected.

Meaning

Pressure switch failure detected.

The F31 error indicates that the washer’s pressure switch is not responding correctly. Whirlpool Duet washers use a pressure switch to monitor water level during fill, wash, and drain cycles. If the switch does not open or close at the correct pressure, or if the control board receives inconsistent readings, the washer triggers F31. This error is common when the pressure hose is blocked, the switch diaphragm fails, or wiring becomes loose.

Symptoms

  • Washer overfills or underfills
  • Washer stops during sensing
  • F31 appears early in the cycle
  • Unexpected draining during fill

Causes

  • Blocked or kinked pressure hose
  • Loose hose connection
  • Faulty pressure switch
  • Air dome clogged with residue
🔧

Step-by-Step Fixes

  • Inspect the pressure hose for kinks or blockages.
  • Ensure the hose is firmly connected at both ends.
  • Clean the air dome on the tub.
  • Replace the pressure switch if readings are inconsistent.
⚠️

Safety Notes

  • Disconnect power before servicing the pressure system.
📋

Applicable Models

Show Models
  • GHW9100LW
  • GHW9150PW
📁

Related Pages

📁

Other Whirlpool Washer Error Codes

Show All Error Codes

Model-Specific Notes

On Duet models, detergent residue buildup in the pressure hose frequently causes F31 by preventing accurate pressure changes.

Disclaimer

The information provided on this page is for educational and informational purposes only. Repairs involve electrical, mechanical, and water-related risks. Always follow manufacturer instructions and consider contacting a qualified technician for diagnosis or repair.

Copyright 2026. All rights reserved.